Discussion

Manage overtime

October 6, 2014 - 11:27 am
3 comment(s)

Hi,

I have been looking how to manage de overtime of the resources and the only thing that I have found is only to place the overtime rate. I have the following doubts:

1. How can I see how much overtime my resources have used?

2. It is a way that a task can begin in an overtime period? I saw that a task can finish in overtime period when it begins in working time but then the next task wait until working time begins again.

3 Comments

October 15, 2014 - 06:43 am

You can see the overtime in the histogram.... a task will not start in an overtime period.  that is a good question

October 31, 2014 - 16:36 pm

Hi all,

I got some strange issue on my "test-project" which I want to use as a short ProjectLibre training for a few workmates.

If I want to check the overtime of my ressources at the histogram, the maximum seems to be at 70%. Also I know there is some overtime but it`s not shown how it should be. I adjust the max. ressources on 100% and as well put the ressource use on 100% on every task. Is there anything else wich can affect this value? (same issue on the chart-view)

If I create a new project everything is shown right.

Best regards,

Robin